Slide your heatshrink tubing over the end of the wire. Strip the insulation from the wire so that the copper will bottom out in the connector cup, with about 1/16" (1-1.5mm) left bare beyond the end of the cup.
Clean the wire with some alcohol & a cotton wipe, taking the opportunity to twist the strands back together. Tin the wire with your solder. Use a large paperclip or tweezers to prevent heat transfer that might melt the insulation. Locking forceps can work if you bend the handle so that the jaws don't crush the wire.
Once the wire cools, coat it with a thin layer of flux. Then cut a length of solder to fit into the connector cup. Insert the tinned wire next to the solder strip and heat the cup. At the exact moment when the strip of solder melts and blends with the tinned wire, rock the wire away from, and then back down against the back of the cup, and remove heat. Hold it still while it cools.
Slide the heatshrink over the connector and shrink it with a heat gun. Don't use a lighter - it chars the insulation and you'll have to start over. Most hair dryers don't get hot enough (darn safety rules!)
Okay, so that sucks.
>razor sharp shards of glass ricocheted
Welp, you literally dropped a glass glass of water. Good lord, that's scary on a naked computer. This is a pretty awesome hack.
>(Be sure to get your finger partially in front of the lens while documenting this.)
Why does he say this? I don't understand.
I have another question. What is the present status of taking something like this on-board an airplane? Is the extended battery likely to raise alarm at the carry-in security section?
We had no problems, sending it through the airplane, i snuck a peek at the x-ray cause i wanted to see what the battery looked like. Just a bunch of cells.
What are you doing that depletes the battery so fast? I have a 2012 13" MacBook Air which lasts 8-9 hours. My typical use is: display set to 50% brightness, WiFi turned on, mostly using Adobe CC apps.
http://www.everymac.com/systems/apple/macbook-air/macbook-ai...
[1] Something like this: http://www.isplc2006.org/b2b/graphite/5/universal_plug_adapt... I've got a round shaped one with a "Fuji" logo on the side I got at Heathrow I believe.
